Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My boyfriend
09-27-2011, 11:51 PM (This post was last modified: 09-27-2011 11:52 PM by Stockingman.)
Post: #2
RE: My boyfriend
(09-27-2011 12:08 PM)babybear619 Wrote:  My boyfriend is interested in encasement but not encasing me. He wants to wear the nylons. Is this unusual and where do i begin? Help wold be much appreciated

No, it is not unusual............ for a guy to want to wear nylons. Smile

I presume you mean that your boyfriend wants to be encased in pantyhose. I would suggest you both do it. You can easily encase using three pair, each. Suggest you get three pair each in teh largest size you can such as JMS size 4. Take one pair and cut two slits, one in the front and the other in the rear of the panty........ a few inches from the croutch pad. This pair, one leg is gently worked down over the head and arms through the slits, pulling the waistband as far down as it will go. Just tuck the loose leg or double the head covering.

Take the second pair, remove the croutch pad and put head through that. Arms go in the legs, again pulling the waistband down as far as it will go.

Put on the third pair normally, pulling the waistband up, overlapping the upper pair. You may wish to overlap the inner upper pair, then use the outer upper one to over lap the lower pair, which would guarantee total coverage.

If you work the leg down over the head, not pulling it so it does not distort, then open mouth widely and close, you will find that liquids can easily be drank through the material and it is quite flexible which can encourage sensual nylon to nylon kissing etc. (wink)

Hope that helps................ Wink
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
My boyfriend - babybear619 - 09-27-2011, 12:08 PM
RE: My boyfriend - Stockingman - 09-27-2011 11:51 PM
RE: My boyfriend - babybear619 - 09-30-2011, 06:05 AM
RE: My boyfriend - n2hosiery - 03-15-2022, 12:30 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)